کنفرانس بین المللی ماشین و محرکه های الکتریکی

صفحه اصلی / The 3rd International Conference on Electrical Machines and Drives

An Optimal Design and Analysis of Pole Shaping in HTS Coaxial Magnetic Gear

نویسندگان :

Mostafa Madanchi Zaj¹ Seyed Ahmadreza Afsari Kashani²

1- University of Kashan 2- University of Kashan

کلمات کلیدی :

magnetic gear،eccentric structure،spoke-type،FEA،HTS،cogging torque

چکیده :

This paper presents an optimal design of rotor pole shaping topology in spoke-type interior permanent magnet radial flux magnetic gear with high temperature superconductive bulks to increase torque density and decrease cogging torque. Spoke-type topology faces some problems as PMs on the rotor require a hub design to avoid magnetic flux leakage. The flux flow route is not the same, resulting in different reluctance levels depending on the source point. Proposed design is based on applying non-circular structure on inner rotor’s surface and using the dome shape flux barrier to eliminate the need for hub arrangement. In this paper the performances of magnetic gear with thinner high temperature superconductor combined with ferromagnetic pole pieces as modulator middle rotor is optimized and analyzed. The proposed magnetic gear including 3 inner and 12 outer pole pairs. Results show that by applying recommendations, the desired objectives are achieved. The topology performance is assessed and verified by finite element analysis.

لیست مقالات

لیست مقالات بایگانی شده

A High-Voltage DC-DC LLC Resonant Converter by Using a Symmetrical Voltage Multiplier Circuit

Reza Takarli - Mohammadreza Adib - Abolfazl Vahedi - Reza Beiranvand

طراحی کنترلر ماشین القایی دو سو تغذیه با قابلیت پشتیبان اینرسی و هماهنگی پاسخ با ذخیره‎ساز انرژی

محمد امین خنجری - محمدرضا بسمی

Fault-Tolerant Control of Three-Phase Induction Motor Based on Predictive Feedforward Method

S. Alireza Davari - Mahdi S. Mousavi - Amir Hosein Valiloo - Freddy Flores - Majid Rahmani - Yuzhe Zhang - Zhenbin Zhang - Jose Rodriguez

Thermal Behavior-Informed Inter-Turn Fault Detection of PMSMs using Explainable AI in an Attention-Based Deep Learning Framework

Amir Hossein Baharvand - Sina Hossein Beigi Fard - Amir Hossein Poursaeed - Behrooz Rezaeealam - Meysam Doostizadeh

A LCC-LCC Converter with Near Constant Output Voltage for Autonomous Underwater Vehicles

Ahmad Siroos - Ebrahim Afjei - Xiaodong Liang - Alireza Sheikhi Fini

Modeling and simulation of a Novel Actuator for Medium-Voltage Vacuum Circuit Breakers Based on PMSM Servo Drive

Shahin Mahdiyounrad - Hamid Ashrafi - Hamed Mohajeri

Electromagnetic Analysis of a New Delta-Type Consequent-Pole IPM Motor for PM Cost Reduction

Amir Ebrahimi Shohani - Mohammadreza Naeimi - Fariba Farrokh - Mohammad Farahzadi - Karim Abbaszadeh

Enhanced On-Board Charger Performance Using Model Predictive Control with Interleaved Totem Pole PFC Based on Asymmetrical CLLC Converters

Reza Hamdi - Hossein Torkaman - Amin Amraei

Improving the performance of Permanent-Magnet Assisted Synchronous Reluctance Motor used in electric vehicles

Seyed Davood Hoseini robat - ُُSeyed Ebrahimُُُُ Afjei

Investigation of A Novel Hybrid Reluctance Motor Utilizing PMs in the Rotor Poles with a Gap

Ali Harooni - Aghil Ghaheri - Mahdi Abolghasemi - Ebrahim Afjei

بیشتر

ثمین همایش، سامانه مدیریت کنفرانس ها و جشنواره ها - نگارش 43.6.0